XPS Extruded Polystyrene Foam Board - SA-XPS

XPS Extruded Polystyrene Foam Insulation Board (B1 and B2)

For use as the insulant in external wall insulation systems

DESCRIPTION

XPS is an extruded polystyrene insulation manufactured through a plastic extrusion process. The resulting board is almost 100% closed cell, strong, highly moisture resistant and easy to cut and shape.

ShunanInsulation Polyfoam extruded polystyrene (XPS) is particularly indicated for places where a high mechanic resistance is required. Its resistance to water and compression make it the ideal insulation solution for extreme conditions. Moreover, it is very easy to install and offers a high performance thermal insulation for your building

This makes them ideal for applications in the construction industry as they are equipped for 'site survival' and can be cut to shapes that make them extremely fit for use. It also means that Polyfoam is ideal for a vast range of fabrication applications where the strength of the material as an infill in panels etc. is widely recognised and valued.
In short Polyfoam is two solutions in one......both a thermal AND structural insulation solution

PRODUCT INFORMATION

• Slab Size: 1200mm×600mm
• Color: Blue,yellow,a range of colours
• Storage: Dry place; Avoid wet or sun exposure
• Curing Time: ≥ 42days
• Standard: JG149-2003

TYPICAL XPS APPLICATIONS

Flat and pitched roofs

External walls insulation

External cladding

Floor insulation

Specific applications

Also indicated for the insulation of cold rooms, agricultural buildings, as well as for industrial and leisure vehicles.

SA Insulation Polyfoam XPS insulation solutions provide you with:

• Resistance to compression: The inherent mechanical strength of Polyfoam make it the ideal solution for heavy domestic or industrial loads
• Water resistance: Polyfoam is almost 100% closed cell and as such is unaffected by moisture
• Lightweight: volume optimisation and easy to handle
• Resistance to deformation
• Resistance to impact
• Versatile: the closed cell structure and density of Polyfoam allow specific edge details and surface finishes to be cut into the boards to make them as fit for the job as possible. Moreover, Polyfoam can be cut into almost any shape
• 100% ozone friendly
• Recyclable: Polyfoam is a polystyrene foam insulant and as such is 100% recyclable

TECHINICAL DATA

MANAFACTURING PROCESS

SA XPS System is a lightweight, low density system employing expanded polystyrene insulation with adhesive and mechanical dowel fixings

Construction Guide

1. Concrete

2. Adhesive

3. Insulation

4. Rendering coat mortar (SA802)

5. Fiberglass mesh(160 g)

6. Rendering coat mortar (SA802)

7. Flexible waterproofing external wall putty

8. The finishing coat

Remarks for EIFS system

• The temperature of air and glue must be from 5°C~35°C
• Avoid sunshine, high temperature and freezing
• Avoid strong wind during application
• Avoid rain during application
• Polystyrene board must be applied closely one by one. The width of the gap must be less than 2mm, otherwise fill it with polystyrene strip. It is forbidden to to fill with glue between two boards
• The level deviation between two boards must be less than 1.5mm