Vertical Design Automatic Filling Valve - AF0522B

Overview:

The automatic filling valve is a device consisting of pressure reducing valve, stainless steel filter, shut-off valve and a check valve

This water fill valve with visual design, installed on the water inlet piping in sealed heating systems, and its main function is to maintain the pressure of the system stable at a set value, automatically filling up with water as required.

This automatic filling valve has the characteristic of being pre-adjusting, which means that it can be adjusted at the required pressure value before the system charging phase.

After installation, during the filling or topping-off phase, the water feed will stop when the set pressure is reached.

The automatic filling valve built-in shut-off valve and check valve.

The automatic filling valve with large diaphragm-seat seal working surface, bigger 40% more than general product, guarantees greater precision and sensitivity to maintain its operating characteristics unchanged overtime.

Technical parameters:

Max. pressure inlet : 10bar

Pressure adjustment ranges: 0.3~4bar

Pre-pressure: 1.5bar

Max. temperature: 80°C

Connection: G 3/4" male thread inlet and can match with other slipknot for G1/2" male thread, G 1/2" female thread outlet

Other threaded coupling for custom-made

Pressure meter connection: G 1/4"

Body material: H59 brass

Seal material: NBR rubber

Mounting instruction:

1. Filling unit can be installed in either horizontal or vertical position. It is, however, vital that the unit is not installed upside down. Direction arrow is inlet.
2. AF0520 unit, 0.2 bar pressure will be added by screwing the knob on the top one circle in clockwise direction, conversely, the pressure reduced.

AF0522 unit, no need to install pressure meter, just adjust the pressure at a set value before filling.

1. Auto filling unit, the outlet pressure should over 0.3bar than the static pressure, and the setting pressure should less than the filling pressure or it can not work normally. It is normally installed at water backflow part.
2. Automatically filling, until it reaches the required valve.
3. When filling water, the shut-off valve can be closed by hand.
4. The valve disk can be cleaned or changed.