PVCFlooring - MCF323-2

ApplicableRange: Paste on ground directly, fit for locations where need clean and antistatic places such as distance control machine room, computer room, clean workshop in communication and electronics industry

Ground requirements

1. The basic ground should be clean, dry and flat
2. The foundation should be cement or terrazzo ground, but couldn’t have the phenomenon of sanding and separation. The strength of surface cement can not be lower than no.75
3. The ground should be flat; the unevenness must be less than 2/2000 mm or make self-leveling cement ground
4. If the foundation is formation, the ground must do waterproofing

Note of installation

At installation the ground residual moisture should not exceed 2.5%(CMDUMB test). The floor, adhesive and job site’s temperature must keep above 18 degrees Celsius in 24 hours before the installation. High quality conductive adhesive and copper foil must be used in the installation

Note of installation

Maintenance

1. Putting mats outside the door to gated of the sand so le can reduce the damage to the floor
2. Avoiding sharp scratches on the floor by hard object, and maintain a smooth surface.
3. Clearing the floor by neutral detergent, dry after washing, and then coat it with anti-static wax

Application

1. Electronics microelectronics
2. Telecommunications environment
3. Raised access floor
4. Healthy equipment
5. Clean room
6. Computer room
7. Electric equipment