LS Spiral Elevator | screw lift elevator(tongxin brand) - LS

LS Spiral Elevator | screw lift elevator(tongxin brand)

LS screw hoist with plate sleeve roller chain and traction components, hopper fixed to the chain plate, and a continuous layout, using flow-type load, low speed heavy discharge of the Bucket.

LS screw hoist for transport medium and large block, the fragile and abrasive packing density of less than 2t/m3 materials, the material temperature does not exceed 2500C, such as lump coal, ore, gravel, coke, etc.

Technical performance and the main parameters of Table 1

Table 1

Note: The table throughput by filling factor = 0.6 ~ 0.85 calculated.

The main structure features:

This machine mainly by the drive device, the upper section of the central chassis, chain bucket group, the lower section of the form.

3.1 drives:

The machine-driven device consists of ZSYNZ reducer, Y series of motors and triangular belt formed. High-speed reducer with a backstop side to prevent a sudden power failure resulted in the material hopper is equipped with reverse operation, so that the bottom of the materials, blockage or mechanical damage.

3.2 Upper Section:

The upper section of the drive sprocket from the group, the upper chassis, two and a half covers, transmission platform. Groups rotate to chain drive sprocket bucket in part by bottom-up exercise, and to enhance the material together.

3.3 Central Case:

There are three different chassis system in central France, according to the different Bucket height matching, which view the central part of the door casing according to a given number of selected sets of tables.

3.3.1 Central Standard Chassis:

Standards Central chassis equipped with a high degree of size and form according to package selected.

3.3.2 the central part of the door with a view chassis:

In the standard focus on the central chassis as great a view to open three doors, good lighting, easy to view and replace them bucket brigades.

3.4 chain and chain bucket:

Chain for short pitch roller chain plate cylinder discuss hopper bolt fixed to the chain attached to board hopper for the T-bucket, back with the induction discharge baffle.

3.5 Lower section:

The lower section is comprised of tension sprocket group, the lower part of chassis, heavy hammer tensioning devices, feed port, guided Trough to view the composition of the door. Tensioning device by means of heavy hammer, and tighten sprocket group weight, so that the chain tension constant. When the chain wear elongation may automatically adjust the wheelbase and have a dampening effect. View when the door is easy to overhaul the demolition hopper and chain, the lower part of the Qing Liu for the cleaning product mix for the door.