Excellent Resistance Non Shrink Grout - CSTG1000

Production Description

Colorsource Tile Grout, a premium quality cementitious grout, is enriched with selective additives and specially designed for joints grouting in ceramic, terracotta, marbles, granite, terrazzo, mosaic and natural stones used in both internal and external areas.

Technical Data

Advantage

Colorsource tile grout is easy to use, good workability, excellent resistance to aging, fungus, non-acidic solvent, water and dampness. It is also excellent bond strength, non cracking or powdering, uniform and colorfast to suit various color tiles with consistent quality.

Surface Preparation

(1) Remove all deteriorated mortar, dirt, oil, grease and other bond inhibiting materials from the joint gap.

(2) Pre-saturate tiles with high porosity and high water absorption rate.

(3) Substrate should be saturated surface dry and free of surplus water prior to application.

(4) Grout installation can be only commenced after a minimum of 24 hours curing time at 21°C.

Mixing Procedure

(1) Place clean, potable water into a clean container. Add pre-mixed Colorsource Tile Grout powder gradually to the measured quantity of water. The mix ratio is depending on the type of grout.

(2) Mix with a slow speed mixer to a smooth uniform, homogeneous consistency.

(3) Allow mortar to stand for 3~5 minutes for additive to dissolve.

(4) Readjust consistency if necessary, remix for 1~2 minutes, and apply with the proper joint grouting tool, such as, sponge trowel.

Application

(1) Using a special tool of sponge trowel, spread and press the grouts into the joint gap evenly, check and make sure no voids or space is left unfilled.

(2) When surface is almost dry (about 20 minutes after application), using a damp sponge with most of water being squeezed out, wipe off the excess grouts remaining on tile surface carefully and ensure that no grouts inside the joint gap is being wiped off.

(3) When the grout is dry (about 12 hours later depend on the weather), use a damp sponge to clean the tile surfaces throughout.

Note:

For black and dark color grouts, please clean the surface of tiles immediately after the application.

(4) Water curing the tile grout after 24 hours application for better result.

Precaution

(1) Allow 24 hours for adhesive set hard before applying tile grout.

(2) Avoid loading the newly installed tile grout for at least 24 hours and protect it from weather elements and water.

(3) No acidic solution is permitted to be used as cleaning agent for the grouts work.

(4) The wet tile grout should be used with the pot life approximate 2 hours.

(5) Once the mortar is dried, it should be discarded and never add water and re-used again.

Storage

1 year shelf life if factory packed, sealed pallets and stored off the ground in a dry area.

Water Dosage

8.0~8.5 litre 32~34% (Non-sanded Color Grout:≤2mm)

7.25~7.75 litre 29~31% (Standard Color Grout: 2~8mm)

5.5~6.0litre 22~24% (Wide Joint Color Grout: 3~12mm)

Special Note

Our companydoes not undertake any losses caused by incorrect use of the product.Please follow the instructions closely when application. For further information, please feel free to contact us directly.

Silica sand and cement materials are used and breathing in of content should be avoided. Observe usual precaution to protect eyes and skin while handling dry cement-based powder mortar.

Contact Us

Colorsource B. M. Ltd

Tel: +86 755 82873152 / 83898970 / 83417689

Fax: +86 755 82047135

Trademanager: Dyrus.Hu

Skype:dyrus.hu