Adhesive for aerated concrete - SA813

Brick Adhesive, 1)Excellent bond strength, 2)Water retention, 3)Anti-crack,anti-aging,weathering resisting, 4)Good workability - details see: https://www.buildingsupplieshub.com/adhesive-for-aerated-concrete-10082787

Place of Origin: Shanghai China (Mainland)	Brand Name: SA	Model Number: SA813	Usage: Joint Mortar
Type: Cement Mortar	Color: grey or white	Quality System Standard: ISO 9001-2008

contact supplier for Adhesive for aerated concrete

SHUNAN. Aerated concrete adhesive

SA813 is a dry mix of cement, sand and additives to which only water is added in order to obtain a ready-for-use adhesive mortar for cellular concrete and otherlight-weight building elements.
SA813 has a very good resistant strength and a long open time. Workability isexcellent

Product information

Directions for use

Mix thoroughly 40 kg of SA813 with ± 10 litres of clean water. Let the SA813 settle for 10 to 15 minutes before mixing it thoroughly once more

Mixing ratio Consumption Packaging
± 10 l water per bag of 40 kg Depending on the width of the stone 40 kg
Colours Processing time Application temperature
White ± 3h + 5°C till + 35°C .

Properties

- Mineral

- Weatherproof, and resistant to frost after hardening

- Strong friction bond due to the adjustment of the water retention properties to suit the absorbency characteristics

of the aerated concrete

- NO rapid loss of water, or loss of water to the subsurface

- Easy correction of brick position after the brick has been laid

- Good workability

- Fulfills the mortar requirements for subsequent thin plastering

Processing

♥ Add the 40kg of dry mortar contained in the sack to approximately 10 litres water and mix, either by hand or using a mixer, to a smooth workable paste. The correct consistency has been achieved if the mortar stands in a stable ridges when scored with a notched trowel. After allowing the adhesive to rest for approximately 5 minutes, mix the mortar again briefly. Apply the mortar without adding any further ingredients.

♥The first layer of high precision units must be laid horizontally and flush in the mortar bed. Before laying and bonding the second layer of units, level off any uneven areas. Clean any dust from the surfaces of the units.the adhesive should be applied for no more than 2 or 3 high precision unit lengths at a time. Apply by hand or using a mortar sledge to comb the mortar into place in a layer approximately 1 to 3 mm thick. Put the high precision units into place from above, wherever possible, and tap into position using a rubber hammer. Avoid pushing the units along longitudinally.

♥The fresh masonry work must be protected from unfavourable weather conditions such as very high and very low temperatures, frost, draughts, direct sunlight and driving rain (by covering with a plastic sheet, for example). Do not carry out works at air and masonry temperature below +5°C.

Packaging Detail:SA813 is delivered in bags of 40 kg. Every bag contains a polyethylene inner bag that guarantees long-lasting conservation

Delivery Detail:3 days