Tile grout

JAIFIX TG is a hard wearing, water resistant grout for filling joints in exterior and
interior walls and floor tiles, mosaics and clinkers up to 5mm width. l It is easily applied by
hand
and because of its unique composition does not shrink when dry.
PROPERTIES:
JAIFIX TG is composed of precisely graded, pure crystalline, marble powder, a blend of
special cements, water-repellent materials, oxide colours and plasticizers.
JAIFIX TG does not curl up during application and gives a wear and weather resistant
joint with no shrinkage cracks.
AREAS OF USE:
JAIFIX TG can be used on material such as ceramic wall and floor tiles, clinkers and
mosaics, where joints do not exceed 5mm width.
PREPARATION OF SURFACE:
Ensure all tile joints and edges are clean and free of exceeds tile fixing mortar.
MIXING:
Thoroughly mix JAIFIX TG in the ratio of 1 ltr water to 3 kg. JAIFIX TG powder.
Allow to stand for 15 minutes, Stir again before use.
APPLICATION:
Wait until JAIFIX TA has set (approx 24 hours) before grouting. Apply JAIFIX TG
diagonally into the joints with a rubber edged spatula. Remove excess grout with a moist
sponge
before drying.
Do not apply grout to an area which is so large that it cannot be completed within an hour.
Porous
tiles should be moistened with water before grouting.
After the grout has dried and before it has hardened, polish the tiles with a clean, dry cloth
leaving the joints flush with the tiles, 24 hours after grouting, moisten the joins with a wet
sponge.

CONSUMPTION:

1 Kg of JAIFIX TG covers approximately 30 running ft. with 2mm width of joint