PVC Cleaner - PVC Pipe Cleaner

KAWSAR Primer Cleaner is a purple-tinted primer/cleaner recommended for use with PVC
and CPVC pipe and fittings. KAWSAR Primer Cleaner is formulated to remove dirt and oil from the surface of the piping, as well as soften the piping in preparation for solvent welding. Cleaner pigment provides verification that primer has been applied to the pipe surface. Note: This product is not for use in a system using or being tested by compressed air or gases.

DIRECTIONS FOR USE
Read all directions carefully before using this product.
• Do not breathe vapors. Use only in well ventilated area.
If forced air ventilation is used, be sure it does not cause
a fire hazard from solvent vapors. If adequate ventilation
cannot be provided, wear a NIOSH-approved respirator
for organic solvents. • Do not use or store near heat,
sparks, or flames. Do not smoke, eat or drink when
using. Do not take internally. Vapors may accumulate in
low places and may ignite explosively. • Store and use at
temperatures between -15ºF and 110ºF. At
temperatures outside of this range, special care must be
taken to prepare good joints and prevent exposures to
solvents. • Stir or shake before using; if jelly-like, don’t
use. Keep container closed when not in use. • Avoid
eye and skin contact - wear safety glasses with side
shields and wear rubber gloves. • HANDLE WITH
CARE! WILL STAIN MOST MATERIALS AND
SURFACES. • Do not thin. • Verify with local
building codes that the use of KAWSAR Cleaner is
permitted.
1. Square pipe ends and remove all burrs and dirt.
2. Check dry fit of pipe and fitting. Pipe should easily
go 1/3 of the way into the fitting. If the pipe
bottoms, it should be snug.
3. Use a suitable applicator at least 1/2 the size of the
pipe diameter. For larger size pipe systems use a
natural bristle brush or roller.
4. Apply thoroughly to outside surface of the pipe to
the depth of the fitting and inside of the fitting
socket.
5. Use appropriate solvent cement for the pipe being
joined. DO NOT TEST WITH AIR.
This product is not for use with caustic or acidic chemical
solutions. Consult Oatey Technical Department for more
information.